DOD-H350 Drag Reducing Agent

Product Description

Drag reducer is used in long-distance pipeline, only suitable for crude oil pipeline. The polymer produced by special process is suitable for the pipeline which can obtain higher effect of increasing / reducing drag by injecting more drag reducer, and the preservation environment is closer to the appropriate environment. This product is characterized by high flash point, over 93℃, almost no special smell, good environmental protection.The product is applicable to the oil temperature over 20℃ in the oil pipeline. The usual filling concentration is ≥ 15ppm. By adding a small amount of drag reducing agent (ppm level) into the pipeline, the physical effect will be eliminated, the turbulence of high-speed fluid will be eliminated, and the friction of the extended range will be reduced. Finally the purpose of increasing the pipeline transportation capacity and reducing the pipeline operation pressure will be achieved. The performance of the drag reducer is greatly affected by the pipeline working condition. The increase rate of the drag reducer in the factory inspection only represents the data of the drag reducer on the factory’s experimental pipeline. The actual value shall be subject to the local test data.

Application Method

The product itself can be used in most long-distance pipelines. Users need to provide specific parameters of oil pipelines to manufacturers for simple calculation.

The drag reducing agent is injected into the pipeline quantitatively through the plunger pump, and the injection point is required to be at the rear end of the oil transfer pump and as close to the outbound end as possible; for the case of multiple pipelines, the injection point shall be at the rear end of the confluence point of the pipeline. In this way, drag reducer can play its role well.

Packing

This product is packed in IBC plastic tank container, 1000L/barrel. Compliance with transport specifications.

Storage And Handling

The storage condition of the product shall be as cool as possible and avoid light. The best storage condition: the temperature shall be 0℃ to 60℃, and the storage environment shall be dark. The limiting storage temperature is from -5℃ to 70℃. The closer the limiting storage temperature is, or beyond the limit storage temperature is, the physical form of the drag reducer may be damaged and the use of the drag reducer may be difficult.